General Configuration
General configuration, troubleshooting, firmware, and hardware access guides for Dragino LoRaWAN end nodes.
General Configuration
AT Commands & Downlink
Send AT commands and downlink payloads to LoRaWAN end nodes.
Device Keys
How to get device keys, EUIs, and join credentials.
Fixed DR, SF & TX Power
Fix data rate, spreading factor, and TX power settings.
Frequency Band
Configure frequency bands for different regions.
Rejoin Server Switch
Switch end nodes between LoRaWAN network servers.
Transmit Interval
Configure uplink transmit intervals for end nodes.
Uplink Dwell Time
Comply with regional dwell time regulations.
Firmware and Hardware Access
BLE Configuration
Configure end nodes over Bluetooth Low Energy.
LDS02/LHT52/LWL02 Firmware
Firmware upgrade instructions for LDS02, LHT52, and LWL02.
LHT65N Firmware via PB01
Upgrade LHT65N firmware using the PB01 programmer.
STM32 Firmware Upgrade
Upgrade firmware on STM32-based end nodes.
UART Access Checklist
Checklist for accessing end nodes via UART.
Troubleshooting and Interfaces
LoRaWAN Communication Debug
Debug LoRaWAN communication issues with end nodes.
Non-Encrypted Packet
Transmit non-encrypted LoRaWAN packets.
RS232 Sensors
Connect RS232 sensors to LoRaWAN end nodes.
RS485 Sensor Notes
Connect RS485 sensors and nodes to LoRaWAN.
RS485 Configuration Tool
Use the RS485 configuration tool for sensor setup.